|
Test printed the eyelash mould... it lifted off the bed a little and the filament isn't yielding the finest results... but I think it's enough for a test cast. If it works out I can go ahead with re-print the rest of the face mould. 
0 Comments
Since the size of the eyeball has changed, I'm taking this opportunity to try something new. Firstly the eyeball will sit on a swivel point with pre set position nobs which should make it easier to position the eyes and keep them in a set position. Secondly planning to coat the eyeball with a translucent layer to make it more shiny. Will need a lens too to cover the iris.  Trying a new method for creating the eyelashes. One mould with multiple injection holes. This might need some refinement. Might need to pre-fill the hard to reach places before putting the mould together and injecting the silicone to avoid air bubbles getting trapped in corners... or add more air holes.  The face part of the face mould was the final piece that needed updating to the new eye position. That completes the update for the face mould. Still need to update the eyeball mould, iris and eye fill moulds and the eyelash and eye brow moulds. Want to experiment with a different method for creating eyelashes and eyebrows. Also have an idea that might make filling the moulds easier and less messy...  |
DEV logThe place for rough work in progress updates and recent developments. No glossy, polished imagery, just raw, straight from the workshop screenshots & photos. SHOP
FundingYou can support my work by donating to the following bitcoin address:
bc1q0zz2xmfvljtrmaua48wl9e2nxhfgcs6xd4jpdt 
Or by doing some of your everyday shopping on our online shop.
Archives
October 2023
Categories |
RSS Feed